$262.80 SGD
| /
| Brand | RECARO |
| Series Name | BASE FRAME SEAT RAIL LEFT SEAT |
| Product Number | 2030.002.1 |
| Compatible Car | ALFAROMEO 4C 96018 |
| Product Description | Year: 2014-07- Notes: The vehicle at the time of development does not have a built-in side airbag in the OEM seat. When a vehicle with a side airbag is released in the future, the airbag warning light will need to be turned off. In addition, the passenger seat is not equipped with an occupant detection sensor. The seating position differs depending on the seat to be installed, RMS or RS-G. In the case of RMS, the top hole position of the RMS side adapter is almost the same as the height of the OEM seat, the second hole from the top is about 15mm lower, and the third hole from the top is about 27mm lower. The bottom hole cannot be used because the seat hits the floor. In the case of RS-G, the rear hole position of the RS-G side adapter is about 16mm lower than the height of the OEM seat (the upper hole cannot be used because it interferes with the roof). The offset adapter cannot be used because it raises the seating position, so please use the standard RS-G side adapter. The steering wheel offset is about 5mm closer to the door from the steering wheel center. The seat slide amount is increased by about 10mm compared to the genuine product, but with the RMS, the rear half of the slide position is limited by interference from the rear side. (When the measured hole position of the side adapter is the lowest on the front side and the third from the top on the rear side), with the RS-G, the top of the seat and the roof interfere with each other by up to about 7mm at about 50mm behind the slide position. The slide amount is also limited by about 20mm. If the hole position is moved up, the slide amount will be greatly reduced due to interference, so it is not possible. Notes / Interference information: The slide amount to the rear is limited depending on the position. With the RMS, the rear half of the slide position is limited by interference from the rear side. (When the measured hole position of the side adapter is the lowest on the front side and the third from the top on the rear side), with the RS-G, the slide amount is limited by interference from the 50mm behind the slide position. (When the measured hole position of the side adapter is the lowest on the front side and the third from the top on the rear side) If the hole position is moved up, it will not be possible to slide due to interference. Please adjust the RMS to the optimal position (front-to-back height, left-to-right offset 0/5/10mm) using the separately sold RMS side adapter before installation. If there is any interference with the interior, it can be alleviated by adjustment. Whether the RMS or RS-G is installed, interference will occur between the seat belt buckle and the center console. Position: New structure frame. One-position type. Armrest: Not installable Compatible seats: Pro Racer RMS Please adjust the RMS to the optimal position (front-to-back height, left-to-right offset 0/5/10mm) using the separately sold RMS side adapter |
| Remarks | (Note) This product cannot be installed on any seats other than those listed in the matching information below. Check with 96018. |
| Notes | Images are for illustration purpose only. Actual product may vary. |
