$286.70 SGD
| /
| Brand | RECARO |
| Series Name | BASE FRAME SEAT RAIL RIGHT SEAT |
| Product Number | 2082.007.2 |
| Compatible Car | MAZDA ROADSTER ND5 RS-G |
| Product Description | Model year: 2015-05- Special notes: The side airbag function built into the factory seat will be lost. The side airbag warning light must be turned off. Install with the included dedicated side adapter. The seating position will be approximately 13 mm lower when the adapter frame is installed compared to the lowest position of the factory seat height adjustment function. When the adapter frame is not installed, the seating position will be approximately 45 mm lower. The Recaro seat handle offset is 5 mm closer to the door compared to the factory seat. When a Recaro seat is installed on the passenger seat, the occupant detection sensor will not function and the seat belt warning light will not turn on. Notes / Interference information: The degree of interference and the amount of sliding will change depending on the installation position and spacer. Please adjust according to the situation. For example (1), if you prioritize the amount of sliding, with the standard installation method (spacer: 15 mm on the door side + 5 mm on the console side, side adapter installation position: front side with lower hole, rear side with upper hole), the rearmost position of the seat slide will hardly interfere with the console or the vehicle's roll bar. When the top is closed, the bow (soft top inner frame) and headrest interfere with each other by about 10 mm. The slide cannot be used up to 6 cm from the front end position. For example (2), please refer to the installation method (spacer: 20 mm on the door side + 0 mm on the console side, side adapter installation position: front side with center hole, rear side with center hole) if you are concerned about interference with the bow. However, the amount of sliding is more limited than in example (1). In addition, the passenger seat has a cup holder, so the amount of sliding forward is limited. The plastic cover for the seat belt pretensioner on the door side can be used without modification. When using in competitions, the adapter frame is removed, so there will be no interference with the bow unless the spacer is moved extremely close to the door side. Position: New structure frame. One-position type. Armrest: Cannot be installed Compatible seats: TS-G / RS-G / TS-W / RS-W |
| Remarks | (Note) This product cannot be installed on any seats other than those listed in the matching information below. Ultra low position frame. RS-G series exclusive frame. The base frame has been changed to allow for more precise adjustment of the seating position. Depending on the installation position, it may interfere with the vehicle. Side airbag canceller included. Install using the exclusive side adapter included with the base frame. |
| Notes | Images are for illustration purpose only. Actual product may vary. |
