RECARO BASE FRAME SEAT RAIL RIGHT SEAT FOR TOYOTA LAND CRUISER J80 SEAT BELT BUCKLE ON FLOOR 80.126.2

RECARO

BASE FRAME SEAT RAIL RIGHT SEAT

80.126.2

TOYOTA LAND CRUISER J80 SEAT BELT BUCKLE ON FLOOR

Model year: 1989-10-1992-07
Special notes: The lowest seating position cannot be used because the floor and levers interfere with each other. Seat offset: Door side: approx. 30mm (Recaro moves closer to the door).
Notes/Interference information: For RS/TS-# series, the handle offset can be adjusted in 5mm increments from 5mm to a maximum of 15mm by using the RS/TS-G offset adapter set (product number 1700001J). (Please consult your dealer regarding interference with the console side (shift, etc.) when installing.) For RMS, please use the separately sold RMS side adapter to adjust to the optimal position (front/rear height, left/right offset 0/5/10mm) before installation. Also, if there is interference with the interior, it can be alleviated by adjustment.
Position: 3 height settings available (For some car models, the legs of the slide rail may need to be cut depending on the installation position. Please test fit before installation.)
Armrest: Left hand armrest can be installed on the right seat
Compatible seats: LX / LX-# / LX-VS / LX-VF / LX-VL / Ergomed / Ergomed C / Ergomed D / Ergomed E / Ergomed LD / Ergomed MV (IS-84 base)
Classic LX Pepita / Classic LX Spektrum
LX-F (IS-05 base)
LS / LS-# / LT-#
CS / CR / CG / Conformed
CSE
CT
C-Classic
DS / DS-H / DS-V / ES-V/DSE
Pro Racer RMS Please use the RMS side adapter (part number 1700002J) sold separately to adjust the RMS to the optimal position (front/rear height, left/right offset 0/5/10mm). If there is any interference with the interior, it can be mitigated by adjusting it. New Orthoped (with Recaro vent)
SR-2 late model / SR-3 / SR-4 / SR-5 / SR-VF / SR-IMPACT / SR-IMPACT Pro
Late model A-8
Early model A-8
SP-A / SP-G / SP-G2 / SP-G3 / SP-GT / SP-GT2 You will need to prepare the side adapter set (part number 1700000J) separately. TS-G / RS-G / TS-W / RS-W For RS/TS-# series, please choose from the two types of side adapter set or offset adapter set for RS/TS-G sold separately. [Priority on seating position] Side adapter set [Priority on offset] Offset adapter set for RS/TS-G Handle offset can be adjusted to 5/10/15mm left and right. (Seating position is raised by +5mm.) SP-X
SR-6 /SR-11/SR-7
SR-S
SR-C/ SR-7F
Sportster
CrossSportster

(Note) This product cannot be installed on any seats other than those listed in the matching information below. Seat belt buckles are attached to the floor.

Images are for illustration purpose only. Actual product may vary.