$300.60 SGD
– Sold Out| /
| Brand | J'S RACING |
| Series Name | FF ROLL CENTER ADJUSTER BALL JOINT VER 20MM |
| Product Number | FCJ-D2-BJ |
| Compatible Car | HONDA CIVIC FD2 |
| Compatible Engine | K20A |
| Product Description | Material: Tylot End S45C Tylot End Ball Stud SCM435 Optimized FD2 geometry and gentle behavior in the marginal range FD2 Civic TYPE-R is DC5 Integra TYPE-R at Tsukuba Circuit Course 2000 in the development process. It was a proposition to pass the time of. As a result, although the car is faster than DC5, there are many parts that are not suitable except for Tsukuba Circuit. Especially in the geometry, the front roll center is too low and the roll axis is tilted forward too much, so it is a characteristic that oversteer suddenly occurs. Therefore, by raising the roll center of the front and suppressing the forward tilt of the roll axis, the behavior in the limit range is made gentle. It is a geometry part that is highly effective not only for low-down cars but also for normal ride height. Since the arm angle when rolling is also appropriate, you can firmly grip the out side tire when cornering. As a result, it exerts various effects such as improvement of cornering speed and suppression of uneven wear. ● Genuine ratio: 20mm correction It is recommended to install the harmonic drive damper and down suspension at the same time. |
| Remarks | Engine: K20A * Alignment adjustment required * Brake rotor back plate removal * Observe the specified torque when installing and install correctly. * Depending on the vehicle height and camber condition, the optimum toe adjustment range may be exceeded. Need to do the alignment after install this parts. * Please check the tightening of bolts and nuts regularly after mounting. Please do this every time, especially before driving on the circuit. |
| Notes | Images are for illustration purpose only. Actual product may vary. |
