RECARO BASE FRAME SEAT RAIL LEFT SEAT FOR TOYOTA ALPHARD VELLFIRE GGH ANH20 25 PASSENGER SEAT GENUINE ELECTRIC FRONT SEAT SLIDE VEHICLE 2080.279.1

RECARO

BASE FRAME SEAT RAIL LEFT SEAT

2080.279.1

TOYOTA ALPHARD VELLFIRE GGH ANH20 25 PASSENGER SEAT GENUINE ELECTRIC FRONT SEAT SLIDE VEHICLE

Model year: 2008-05-2015-01
Special notes: The side airbag built into the factory seat will no longer function. The airbag warning light must be turned off. The seating position will be 10mm lower than the lowest position of the factory seat. (When using ST-JJ). The forward slide amount is reduced by approximately 20mm compared to the factory. If a Recaro seat is installed in the passenger seat, the occupant detection sensor will no longer function and the seat belt warning light will no longer be lit.
Notes / Interference information: The seating position will be higher for CS and CSE due to the use of a spacer. For RMS, please adjust the position to the optimum position (front-rear height, left-right offset 0/5/10mm) using the separately sold RMS side adapter. Also, if there is interference with the interior, it can be alleviated by adjustment. For RCS, please adjust the position to the optimum position (front-rear height, left-right offset 0/5/10mm) using the separately sold RCS side adapter.
Position: New structure frame. One-position type.
Armrest: Can be installed on the right hand side of the left seat and on the left hand side of the right seat
Compatible seats: LX / LX-# / LX-VS / LX-VF / LX-VL / Ergomed / Ergomed C / Ergomed D / Ergomed E / Ergomed LD / Ergomed MV (IS-84 base)
Classic LX Pepita / Classic LX Spektrum
LX-F (IS-05 base)
LS / LS-# / LT-#
CS / CR / CG / Conformed
CSE
Pro Racer RMS RMS is installed after adjusting to the optimal position (front-to-back height, left-to-right offset 0/5/10mm) with the separately sold RMS side adapter . In addition, if there is interference with the interior, it can be softened by adjustment. New Orthoped (with Recaro vent)
RCS Please adjust the RCS to the optimal position (front/rear height, left/right offset 0/5/10mm) using the separately sold RCS side adapter before installation. *Please choose from the following two types. ・RCS side adapter ・RCS stainless steel side adapter set SR-2 late model / SR-3 / SR-4 / SR-5 / SR-VF / SR-IMPACT / SR-IMPACT Pro
Rally Special / First generation SR / SR-2 early model
Late model A-8
Early model A-8
SP-A / SP-G / SP-G2 / SP-G3 / SP-GT / SP-GT2 You will need to purchase the side adapter set separately. SP-AN / SP-GN / SP-GN 2 SP-AN / SP-GN / SP-GN 2 require the separately sold SP-GN side adapter set (product number 1600110J). PRO RACER (RACER) SP-G/A side adapter set (product number 1700000J) must be purchased separately. AM19 TREND-J/JJ/JC
AM19 STYLE-J/JJ/JC
AM19 SPORT-J/JJ/JC
AM19 TREND-JS
AM19 STYLE-JS
AM19 SPORT-JS
AM19 TREND-D/DC
AM19 STYLE-D/DC
AM19 SPORT-D/DC/MAGNIFICA CL222HV
TS-G / RS-G / TS-W / RS-W Side adapter set (product number 1700000J) must be purchased separately. SP-X
SR-6 /SR-11/SR-7
SR-S
SR-C/ SR-7F
Sportster
CrossSportster

(Note) This product cannot be installed on any seats other than those listed in the matching information below. Passenger seat frame (left seat). Can only be installed on vehicles with genuine electric front seat slides. Manual slide vehicles have separate settings. If the armrest is installed on a vehicle equipped with a system console (heat-retaining refrigerator), the lid of the system console (heat-retaining refrigerator) cannot be opened or closed. Side airbag canceller included.

Images are for illustration purpose only. Actual product may vary.