$268.06 SGD
| /
| Brand | RECARO |
| Series Name | BASE FRAME SEAT RAIL RIGHT SEAT |
| Product Number | 2088.002.2 |
| Compatible Car | MAZDA CAROL HB36# CVT VEHICLE |
| Product Description | Model year: 2014-12- Special notes: The side airbag function built into the factory seat will be lost. For vehicles equipped with side airbags, the airbag warning light must be turned off. Compared to the lowest position of the factory seat height adjustment function, the seat will be 5mm higher when the adapter frame is installed. When the adapter frame is not installed, the seat will be 33mm lower (when using New LX-F). The handle offset of the Recaro seat is the same as the factory seat. *If you are installing RS-G/TS-G, please refer to the compatibility information for 5MT as the seating position is different. The forward sliding amount is reduced by 20mm compared to the factory. When a Recaro seat is installed in the passenger seat, the occupant detection sensor will not function and the seat belt warning light will not be turned on. Notes / Interference information: For the Orthoped, the seat backrest interferes with the door trim by 5mm. For the IS-05 series SR-6, 7, and 11, the shoulder part interferes with the B-pillar by 10mm. For the AM190/307 series (Sportster/Cross Sportster), the shoulder part interferes with the B-pillar by about 8 mm. For the RS/TS-# series, the RS/TS-G offset adapter set (product number 1700001J) is required. However, the steering wheel offset is 15 mm closer to the console than the genuine one when a 10 mm spacer is inserted on the door side. Also, if the included 38 mm adapter is not used and the RS/TS-G offset side adapter is used in the lower position, there is no interference with the B-pillar, but if the upper position is used, there is interference of about 1 to 5 mm. Even if the spacer is used and the lower position is used, there is interference of about 1 to 5 mm near the rearmost part of the seat rail. For the RMS, please adjust the RMS side adapter (sold separately) to the optimal position (front/rear height, left/right offset 0/5/10 mm) before installing. Also, if there is interference with the interior, it can be alleviated by adjustment. For the RCS, please adjust the RCS side adapter (sold separately) to the optimal position (front/rear height, left/right offset 0/5/10 mm) before installing. Position: New structure frame. One position type. Armrest: Not mountable Compatible seats: LX / LX-# / LX-VS / LX-VF / LX-VL / Ergomed / Ergomed C / Ergomed D / Ergomed E / Ergomed LD / Ergomed MV (IS-84 base) Classic LX Pepita / Classic LX Spektrum LX-F (IS-05 base) LS / LS-# / LT-# Pro Racer RMS RMS should be adjusted to the optimal position (front-rear height, left-right offset 0/5/10mm) using the separately sold RMS side adapter RCS Please adjust the RCS to the optimal position (front/rear height, left/right offset 0/5/10mm) using the separately sold RCS side adapter before installation. *Please choose from the following two types. ・RCS side adapter SR-S SR-C/ SR-7F Sportster CrossSportster |
| Remarks | (Note) This product cannot be installed on any seats other than those listed in the matching information below. For CVT vehicles. Side airbag canceller included. Compatibility with vehicles equipped with optional items has not been confirmed. |
| Notes | Images are for illustration purpose only. Actual product may vary. |
